Ambientika wireless+
15 April 2016
Show all

Ambientika advanced+


SKU: 4893273177373. Category: .

Additional characteristics

  • remote controller included
  • 2pcs G3 filter included
  • equipped with humidity sensor
  • equipped with light sensor
  • possibility of various settings and programs
  • the device can be connected via cable to other 15 devices
  • could be installed also in the bath room

General characteristics

  • The electrical contacts of the two buttons (On /Off and Speed control) can also be wall mounted.
  • It is also possible to connect the product to the home automation network (Building automation)
  • ceramic heat exchanger with an efficiency of up to 93%
  • compact, versatile, and easy to use
  • made of high-quality resistant materials of aesthetic excellence
  • double separate filters for entering and outgoing air, easily removable and washable
  • no condensate discharge required
  • adjustable aspiration speed with a capacity of up to 60m3/h
  • length of up to 500mm
  • alternated extraction and introduction flow
  • electronically commutated motor (Brushless)
  • reduced power consumption
  • silent operation
  • the direct ejection devices are to be installed on the perimeter walls of the building and they have a duct with a length varying from 250 to 500mm
  • it is possible to duct the exhaust air with a tube of the same diameter to a distance of up to 3 meters. For ducting the exhaust air with the necessity of deviation, the maximum length of the duct (including a 90° bend) will be of 2.5 meters
  • simple ventilation system that does not require ducts
  • easily removable and washable filters and heat exchanger
  • usable for replacement of an existing ejector with minimal intervention


Auto Mode
Automatic operation with heat recovery through humidity and twilight sensors.

Airflow Speed
3 adjustable speed levels: 30 m³/h, 45 m³/h, 60 m³/h.

Umidity Control
Humidity sensor with 3 set values: minimum (40%), medium (60%) and maximum (90%).

Boost Function
It allows the air extraction at the maximum speed for a certain time.

Filter Reset
After 3000 hours opeations the unit requires ordinary maintenance (filter cleaning). Through the same button, after completing the maintenance, the normal operation can be restored.

Surveillance Mode
The product remains in sleep mode keeping the sensors active. In case the humidity level detected in the environment is higher than the preset one, the product will automatically start running until reset values.

Manual Mode
Running mode with heat recovery at the manually set speed (the sensors excluded).

Night Function
It allows to minimise the flow rate and the noise during the night.

Flow Function
It allows to select the direction of the air flow.


In the case of installing several units, the units should be mounted as far apart from each other as possible. This creates a flow of air through the entire living space, making the most effective effect of the ventilation system. One unit covers approx. 30m² of living space.



The product is constituted by a main operating unit with wall joint to be placed inside the room, a recessed tube containing the ceramic exchanger and filters, an external conveyor with wall joint.

Parameter description Measurement units Values
Air flow at maximum speed m3/h 60
Efficiency of the ceramic regenerator % 93
Rumorosità alla velocità massima (a 3 m) dB(A) 24
Noise level at minimum speed (3m) dB(A) 18
Operating temperature °C -20°C +50°C
Absorbed power W 4,9 - 8,9
Filters included 2
Filtering class EN 779 G3
Power supply V/Hz 230 Vac – 50 Hz
Protection IP44